Samsung Range SE Error
What it means
On a Samsung range or oven, SE means a Key Short Error - the control board thinks a button on the touch panel is shorted or being held down too long, so it stops and shows the fault. SE and 5E are the same code; the stylized 'S' is often misread as a '5'. Newer models may show this family of faults as a C-code instead.
The bottom line on the SE error
SE almost always means the board is reading a stuck or shorted key, and the real culprit is usually moisture or grease left on the panel after wiping rather than a dead board. A reset clears it for the moment, but the code returns until the panel is truly clean and dry.
Start cheap: wipe the panel bone-dry and reset the range at the breaker - a free fix for most SE errors. Only if a technician confirms a failed touch membrane or control board does the $150-$350 repair make sense, mainly on a newer range.
SE snapshot
A range runs on high-current 240V wiring โ always cut power at the breaker before any internal panel or wire-harness access, and keep water away from the control while the range is powered.
Our own at-a-glance triage of the SE error, from the verified data on this page. See error-code rankings โ ยท How we score โ
Common causes of the SE error
- A stuck or shorted key on the control panel
- Water splashes, grease, or moisture from wiping the panel sitting on the buttons
- A loose or damaged wire harness between the control panel and the electronic control board
- A failed control panel / touch membrane
- A faulty electronic control board (less common)
Which Samsung ranges get the SE error
SE (5E) turns up across Samsung's electric and gas ranges with a touch control panel, and is frequently reported on the NX58 gas range family (for example NX58H5600, NX58H5650, NX58J5600, NX58F5500) and NE59 electric models. Because it is a control-panel/keypad fault rather than a model-specific defect, it can appear on both older and newer touch-panel ranges.
How to fix the Samsung Range SE error
- 1Wipe the panel completely dryUse a dry, clean microfiber cloth to remove all grease and moisture from the touch panel and buttons. A splash of water or a greasy fingerprint can short a key and trigger SE.
- 2Reset the rangeTurn the range off with the power button, or switch off its circuit breaker for 30 seconds to one minute (5-10 minutes for stubborn cases), then restore power. This clears a transient short.
- 3Free any stuck buttonsGently press each key once to release a mechanically stuck button, then test the range again.
- 4Have the panel / wire harness inspectedIf SE persists, a technician should check the ribbon cable and wire harness between the control panel and the main PCB (often at the CN05 connector), reseat or repair any loose or corroded connection, and replace the control panel (touch membrane) or board if needed. This is internal work behind mains-voltage components.
๐งฐ When to call a professional
If wiping the panel dry and resetting the range do not clear SE, contact Samsung support or a qualified appliance technician. Ranges run on high-current 240V wiring; always disconnect power at the breaker before any internal access, and leave control-board and harness repairs to a professional.
Samsung SE vs Samsung SE vs LG F9: how they compare
How this code stacks up against related error codes for difficulty, urgency, and cost.
| Samsung SE | Samsung SE | LG F9 | |
|---|---|---|---|
| DIY difficulty (1โ5) | 3 | 5 | 5 |
| Urgency (1โ5) | 2 | 4 | 4 |
| Typical cost | $$ | $$ | $$ |
How much does it cost to fix the SE error?
| DIY (dry the panel + reset) | Free |
| Touch panel / keypad part (pro install) | $40-$150 |
| Professional repair (parts + labor) | $150-$350 |
| New range | $600-$2,000+ |
Repair or replace?
Most SE errors are a free fix - a dry control panel and a breaker reset. If the touch membrane or the main control board has actually failed, a professional repair typically runs $150-$350; that is worth it on a range only a few years old, but on an older unit already needing other repairs, replacement can make more sense. Prices vary by model and region, so treat these as rough guides.
Common replacement parts for the SE error
| Touch panel / keypad membrane | $40-$150 | Most common fix for a shorted key; behind mains-voltage wiring - pro install | |
| Main control board (PCB) | $100-$300 | If the board is faulty rather than the keypad; leave to a technician |
Prices are typical retail ranges and vary by model and supplier โ always confirm the exact part number for your appliance before buying. We are not linking parts for this code on purpose: it is a job for a qualified technician, and the right fix here starts with a diagnosis, not a purchase.
Samsung SE error โ FAQ
๏ผ โ Is the SE error the same as 5E on my Samsung range?
Yes. SE (Key Short Error) and 5E are the identical fault - the display's stylized 'S' is commonly mistaken for the number '5'. Both mean a shorted or stuck key on the control panel.
๏ผ โ Why does SE appear right after I clean the stovetop?
Moisture or grease left on the touch panel after wiping can bridge a button and make the board read it as held down. Drying the panel thoroughly and resetting the range usually fixes it.
๏ผ โ Can I keep cooking with the SE error showing?
It is best not to. The control panel is locked out and may not respond correctly. Clear the error with a clean, dry panel and a reset, and call for service if it returns.
Sources & manufacturer references
This guide is independently written and not affiliated with Samsung. Always unplug appliances before servicing and follow your model's manual. Error codes and steps can vary by model โ when in doubt, consult a qualified technician.